3 Alice Street
BASSENDEAN (Perth) 6054, Western Australia
Ph: +61 8 9279 5522 Fax: +61 8 9279 9386

Energy Power Stations

COMPLETE TURBINE WORKSHOP OVERHAUL

  • 200 Ton Crane Facilities
  • Bead Blasting Facilities
  • Metrology Laboratories
  • Turning to 4m dia x 35m long
  • 6 x Floor borers up to 18m travel

  • 9 x Vertical Borers (4 CNC)
  • 5 x Co-ordinate Measuring Machines
  • 2 x Portable Measuring Machines
  • 2 x Laser Tracker
  • Largest Heat Treatment Facility in Australia
  • 7 x 5 axis machines including hard machining of titanium

MANUFACTURE
  • New seals from castings (including S/S) or forgings.
  • Re-engineering from samples.
REFURBISHING
  • Re-caulking of seal strips to refurbish diaphragm seals.
MACHINING
  • Machining a casing on a floor borer.
  • Check split face for distortion and remachine if necessary.
MACHINING
  • Rotor of approx Ř3m.
  • Removal of blades and finish machining of new blades.
INTERNALS OF A GAS TURBINE GEARBOX
  • Ability to fully inspect, manufacture and refurbish all components.
  • Precision Grinding of the gearing to Din 3 quality.
REFURBISHING
Gas turbine gearbox that is being stripped, assessed, completely refurbished and load tested.
COAL MILL GEARBOX REFURBISHMENTS
  • Onsite removal
  • Manufacture of components
  • Worm & wheel manufacture
  • Total refurbishment
  • Onsite installation
ONSITE SERVICES
Onsite measuring using our portable coordinate measuring machine. This can measure in a single set up Ř2.4m to an accuracy of 0.025mm (0.001”). Photo shows performing flatness check on a lower casing. Compliments our Laser Tracker which can span 25m in one setup.
SPARE PARTS
  • Studs from High Temp Steel
  • S/S Springs
  • Governor valves, rollers, positioner etc
  • Cylinder locking strips
  • Control shafts

OVERHAULING A COMPLETE TURBINE ARRANGEMENT
  • Total overhaul within the one premises
  • Customer office available on request.
Download Brochure